How a Gas Buster Works on Oilfield

Gas Buster is also called mud natural gas separator or poor son degasser, which is a safety products used on oilfield to remove often the gas from drilling body fluids. The gas in the drilling fluids is coming from subterranean with very high pressure. The particular worse is that the gas is actually flammable and sometimes poisonous.

Where you can the locate the natural gas buster on an oilfield
Its well known that the solids control equipments prefer remove the solids from the drilling fluids so that the fluids could possibly be reused. Greatly could be preserved by recycling the drilling fluids. Strictly speaking, however the gas buster is not 1 type of solids control products, it always appears as well as solids control equipment. A number of mud engineers will set gas buster out of however ahead of the mud recycling tank, some ones even straight put the gas buster atop the mud tank . When there is drilling liquids coming out from the drilling pit with cut in ruthless gas, unless the gasoline is removed, the drilling fluids will be not be carefully guided to the shale shakers unit for recycling where possible.

drilling mud system
How does gas buster job
The drilling fluids with good pressure gas will be to begin with guided to chock question for pressure relief. And after that the drilling fluids will likely be guided to gas buster. Inside the gas buster there exists a device named distribution water pipe which could decompose big mass gas into small propane bubbles. The gas pockets coming out of the distribution water pipe will directly float max and build up at the higher part of the gas buster boat and then guided out from the water line at the top of the vessel. Typically the slurry coming down will then copied to the shale shaker intended for mud cleaning system .
As mentioned before, often the gas separated by the fuel buster is always flammable as well as poisonous. It cannot be released to environment directly. The normal practice is to guide the propane somewhere 50-100 meters miles away from the rig and the burned by an igniter unit.
Gas buster and igniter device are not used often, they are just like the fire extinguisher. However , to a oilfield drilling site, especially a strong drilling site, they are fundamental.

You are here: Home Blogs How a Gas Buster Works on Oilfield

Contact Us

Phone:+86-15810901775
+86-316-5276989
E-mail:This email address is being protected from spambots. You need JavaScript enabled to view it.

Drilling Mud Decanter Centrifuge Specialist